pad

Click to enlargepadDew-Not Dew Heaters

Proudly made in the USA, the Dew-Not Dew Remover is a thick film heater manufactured for operation at 12 volts. 60% percent of the surface area is heat emitting - this means more even heat distribution and no localized hot spots or burnouts often associated with resistance wire heaters. Protected by over 30 USA and international patents, and carrying more than 20 years of constant improvements and enhancements, the Dew-Not Dew Remover is the ultimate in reliability and efficiency. Dew-Not is available for all popular sized telescopes and custom sizes are available upon request. Each heater comes with a standard six foot cord and phono-plug connector. *Compatible with Kendrick controllers and Dew-Buster.*

So exactly what does this mean? Well for starters it means you use a lot less power. In simple terms the OTHER company design has a large amount of rubber involved as well as the fabric overlay. The result is that you must heat the rubber and the fabric before any heat is transferred to your OTA or device. Thus, a 14"/16” from the OTHER companies heater draws a whopping 4.75 amps at 100% power. By comparison, the Dew-Not 14” strip with it’s unique design only draws 1.92 amps at 100% power. The 16” strip they offer only draws 2.15 amps at 100% power. That is a HUGE power savings.

You will find a similar differences in amperage required between the two with the Dew-Not power requirements being considerably lower in every size available. An old setup needed 11.75 amps at 100% power using the 4 heaters from the OTHER company. Buying the same size heaters from Dew-Not the maximum power requirement is 5.23 amps at 100% power. Thats less than half the amperage of the previous setup. It obvious if you do the math that these save a lot of power and will make a 100 amp battery last a whole lot longer!



pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
pad
DEW-NOT CONTOLLERDEW-NOT CONTOLLERpadThe NEW Dew-Not controller is a dual channel controller based on PWM technology. Each channel controls two outputs for a total of four outputs...
pad
$115.00
pad
pad
Telrad Dew-Not HeaterTelrad Dew-Not HeaterpadLength: N/A

Watts: 2.0

Voltage: 12v

Amperage: 0.17
pad
$28.00
pad
pad
0.965 Dew-Not Heater0.965 Dew-Not HeaterpadLength: 4.5" (11.4cm)

Watts: 2.1

Voltage: 12v

Amperage: 0.18
pad
$18.00
pad
pad
1.25" Eyepiece Dew -Not Dew Heater1.25" Eyepiece Dew -Not Dew HeaterpadLength: 6.5" (16.5cm)

Watts: 3.1

Voltage: 12v

Amperage: 0.25
pad
$19.00
pad
pad
2" Eyepiece Dew-Not Dew Heater2" Eyepiece Dew-Not Dew HeaterpadLength: 9" (22.9cm)

Watts: 4.2

Voltage: 12v

Amperage: 0.35
pad
$20.00
pad
pad
3" Dew-Not Dew heater3" Dew-Not Dew heaterpadLength 13" (33.0cm)

Watts 6.0

Voltage 12v

Amperage 0.50
pad
$22.00
pad
pad
4" Dew- Not Dew Heater4" Dew- Not Dew HeaterpadLength 15.5" (33.0cm)

Watts 7.3

Voltage 12v

Amperage 0.61
pad
$26.00
pad
pad
5" Dew-Not Dew Heater5" Dew-Not Dew HeaterpadLength 16.75" (42.5cm)

Watts 7.9

Voltage 12v

Amerage 0.66
pad
$28.00
pad
pad
6" Dew- Not Dew Heater6" Dew- Not Dew HeaterpadLength 20.5" (52.1cm)

Watts 9.6

Voltage 12v

Amperage 0.80
pad
$31.00
pad
pad
8" Dew-Not Dew Heater8" Dew-Not Dew HeaterpadLength: 30.0" (76.2cm)

Watts: 14.0

Voltage: 12v

Amperage: 1.18
pad
$35.00
pad
pad
10" Dew-Not Dew Heater10" Dew-Not Dew HeaterpadLength: 38.0" (96.5cm)

Watts: 17.8

Voltage: 12v

Amperage: 1.49
pad
$40.00
pad
pad
12" Dew-Not Dew Heater12" Dew-Not Dew HeaterpadLength: 43.0" (109.2cm)

Watts: 20.2

Voltage: 12v

Amperage: 1.68
pad
$44.00
pad
pad
14" Dew-Not  Dew Heater14" Dew-Not Dew HeaterpadLength: 49.0" (124.5cm)

Watts: 23.0

Voltage: 12v

Amperage: 1.92
pad
$46.00
pad
pad
16" Dew- Not Dew Heater16" Dew- Not Dew HeaterpadLength: 55.0" (139.7cm)

Watts: 25.8

Voltage: 12v

Amperage: 2.15
pad
$48.00
pad
pad
BinoView HeaterBinoView HeaterpadBinoview is the ultimate binoviewer optic dew remover. Using the same technology as our standard Dew-Not dew remover, Binoview helps ensure the clearest nighttime viewing possible. Includes tandem wraps for Binoviewers-two 6" wraps joined with 4" jumper. One power supply cord. Power takeoff plug for powering heater for objective, Starbeam, etc.

Length 13" (33.0cm)

Watts 6.0

Voltage 12v

Amperage 0.50
pad
$44.00
pad

Every effort has been made to ensure the accuracy of all information contained herein. SmartAstronomy makes no warranty expressed or implied with respect to accuracy of the information, including price, product editorials or product specifications. Product and manufacturer names are used only for the purpose of identification. The image displayed for every product might not be the exact picture. This is used for display purposes only. Please read the Info for more information about our store policies. All trademarks and registered trademarks are the property of their respective companies.
 

Copyright (R) 2004 SmartAstronomy, All rights reserved.